![]() ![]() Continuous Record Mode: Use continuous record mode to record multiple events automatically. See below for information on the trigger level.ī. Recording begins automatically when an event’s ground vibrations or air pressure exceeds the trigger level. The Minimate Plus records the event, displays the results, and stops. Single Shot Record Mode: Use single shot record mode to record one event automatically. The Minimate Plus offers the following recording modes:Ī. Please refer to Chapter 3.8.1 of the Minimate Plus Operator Manual, page 3-8, for more information.Ī record mode determines how the Minimate Plus records events. Click Test Communication and it should be tell you that Blastware can communicate with the unit.Select “Static IP Address” and Input the IP you got from the minimate Put your port “9034”.Select “ Ethernet/Modem Communications” Protocol: TCP/IP.Port: COM1: Baud Rate: 115200 Retries: 2 Timeout Factor: 1 Modem Type: No Modem Check “Modem Communication using a Comm port redirector” option.Open Blastware and Click on Unit and then Communication.In Minimate the IP address is in Setup=>Maintenance Menu=> View Ethernet Data => Automatic: IP (note down the IP). Disconnect all other Ethernet connections other than the one from Auxiliary of the unit to your laptop.Please follow the Instructions below if you are using an Ethernet cable connected to the Auxiliary port. ![]() To save a local copy you can then select Copy and save the events. To view saved events select Series III unit from the event manager.Press Test Communications and confirm the Unit Communications OK dialogue box opens.Open Unit/Communications window and select the Com port from the device manager window to communicate as well as check the Serial communications box.Open Blastware and select the correct unit type at the bottom of the window (Blastmate III unit and Minimate Plus = Series III and Blastmate II = Series II).In your PC device manager verify the com port that you need to choose to communicate with the unit in Blastware.Follow Dropbox link if this isn’t automatically completed or you have issues with next steps ( ).Driver software may require installation.Connect Minimate Plus/Blastmate-III to PC via USB Cable – Unit should beep.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |